About the Wheelchair Adapter Plate (WC-AP)

The Wheelchair Adapter Plate (WC-AP) is used to mount to chairs or mounts that have a hole spacing associated with it.
Wheelchairs that have a series of holes along the seat rail can typically be mounted with a WC-AP.
This plate fits 1/4" or 6mm bolts, and spans from 1 inch [25mm] to 2 inches [50mm].

Once attached, the Wheelchair Adapter Plate (WC-AP) can mount to the hardware below:

• Ρυθμιζόμενο βραχίονα αναπηρικής πολυθρόνας WB(Adjustable)
• Στερεό βραχίονα αναπηρικών αμαξιδίων WB2(Solid)
• Wheelchair L-Angled Extension Plate WC-LAE
• Πλάκα προσαρμογέα αναπηρικής καρέκλας 2 WC-AP2

Wheelchair Adapter Plate (WC-AP)

Wheelchair Frame with Hole Spacing
(Round & Square/Rectangular)

Attaching an Adapter Plate to Wheelchair Frame with Hole Spacing

Επιστροφή στην κορυφή

Example 1: Mounting to Wheelchair Frame with Hole Spacings (Round Tubing).

The picture on the left shows someone lining up the WC-AP to the wheelchair frame holes.
Hole spacing on this particular chair (the Quickie P220) is 1".
Footrest removal is not obstructed in this setup, and the WC-AP could be moved rearward on the wheelchair frame to accomodate if it did.

Example 2: Mounting to Wheelchair Frame with Hole Spacings (Square/Rectangular Tubing).

This picture shows an Adapter Plate (WC-AP) attached to a rectangular rail with hole spacing. If you look closely (click on the picture to enlarge) you can see that there are two holes that can be mounted to.
The larger hole spacing is selected in favor of the tighter hole spacing for the broadest base of support.

Example 3: Mounting to a pre-existing hardware.

There are many instances where a wheelchair already has some mounting hardware attached.
Assuming that the pre-installed hardware is robust enough, it may be easier for people to mount onto that hardware.
Shown above are the Adapter Plate (WC-AP) mounted onto an unknown mounting system, and onto Daedelus systems Multi Hole Adapter.